cfg and /opt/retropie/configs/n64/InputAutoCfg.ini my results are identical to my previous test. I followed the same procedure in my original test, only enabled ssh and wifi, and configured the Retrolink N64 controller using the ES mapping prompt and recommended mappings for lr-mupen64plus.Īfter checking /opt/retropie/configs/all/retroarch/autoconfig/Generic USB Joystick. At this point, the issue still only exists in lr-mupen64plus-next, as far as I can just for curiosity sake I took a Raspberry Pi 3 and loaded the latest 4.5.1 RetroPie image on a fresh SD card. Then I went to go and test with mupen64plus-GLideN64, but I had to modify /opt/retropie/configs/n64/InputAutoCfg.ini because the ES mapping script left it in a dysfunctional state (check out C button D): Generic USB Joystick _STARTĪfter modifying that to match the actual button values (A = button 6, B = button 8, C down = 2), both A and B buttons were functioning as expected in ROM's. Also tested with lr-gambatte on two ROM's and A and B are also working as expected. Just tested with lr-snes9x on two ROMs and both A and B buttons are mapped correctly and working as expected using the Retrolink N64 controller.
Input_state_slot_increase_btn = "h0right"Ĭorrect, jtest confirmed that button 8 is the physical B button, as it is mapped in the auto-configuration file. Thanks in advanced! input_device = "Generic USB Joystick " This is driving me crazy, where else should I check to see what is causing the logical B button to get unmapped or disabled? I've included my joystick config file below if anyone would like to review it. I've also tried removing all the hotkeys from the config file and it has no affect. I've also tried mapping the logical B button to various other physical buttons, and pressing every button on the controller, and it just will not work. cfg" causes the physical A button to work as expected, but the physical B button still will not work for the logical B button (can't back out of menus, etc.) Swapping the A and B button mappings in "/opt/retropie/configs/all/retroarch/autoconfig/Generic USB Joystick.In the emulator, the physical B button acts as the logical A button, and the physical A button doesn't work for the logical B button (can't back out of menus, etc.).Controller buttons work fine and act as they should in ES, jstest, and in the runcommand window.Controller mapped in ES using recommended mappings.Testing Mario Kart 64 and Super Smash Bros on lr-mupen64plus-next using 49-21 video setting (640x480).
#Mupen64plus missing retroarch windows install
0 kommentar(er)
